#Eliminator 2000w inverter manual full

This power inverter has a good starting ability, it only takes about 1 second for two parallel 1000 watt solar lamps. Due to the EG8010 programming reason, the power inverter will continuous work after a few seconds if the power supply is not cut off. Short circuit protection is also set about two seconds to turn off the output. Adjust the inverter power limitation potentiometer, limit the maximum power at 2500 watt, (a little greater than 2500 watt), the power inverter works for less than two seconds before it turn off the output. Maximum connected load was 3000 watt for approx 10 seconds, due to the DC power supply limitation (paralleling a large DC battery and two small batteries), GoHz did not continue test it.

#Eliminator 2000w inverter manual full

This was a full load test on the power inverter, two water heaters, about 2000 watt, the water was boiling completely. The dead zone time was a bit long (1uS), where the zero-crossing point did not look good, in order to ensure the safety of the tube, GoHz did not adjust it. The SPWM accuracy of EG8010 was not high enough waveform, so the inverter output was not good enough as pure sine wave. The picture was taken in short-circuited. Iron loss includes two aspects: hysteresis loss and eddy current loss, which can be calculated by measuring the no-load current of transformers.Few days ago, GoHz made a 24V 2000W power inverter in home, sharing some design schematics and circuit diagrams. When current is heated by passing through the resistance of inductance coil, part of electric energy is transformed into heat energy and lost, and because the coil is usually wrapped by insulated copper wire, it is also called copper loss, which can be calculated by measuring the short-circuit impedance of transformers. Among them, copper loss refers to the loss caused by resistance of inductance coil. It can be divided into copper loss and iron loss. Among them, conduction loss is related to internal resistance and current passing through components, while switching loss is related to switching frequency of components and DC voltage endured by components. It can be divided into conduction loss and switching loss. The main losses of power inverters come from IGBT, MOSFET and other power switch tubes, as well as magnetic devices such as transformers and inductors, which is related to the current, voltage and the process adopted by the selected materials. The only way to improve the efficiency of power inverters is to reduce the losses. Tips: What factors affecting the efficiency of power inverter?

LCD display shows input voltage, output voltage, output frequncy, battery capacity and power.ДЄlarm at first voltage continuously reduce, LED Red light on & shut down.ДЄlarm at first temperature continuously rise, LED Red light on & shut down.

Pure sine wave power inverter is available with remote control: wired control and wireless control.

Pure Sine Wave Inverter Remote Control & LCD Display (Optional) Note: * The AC output is 1-Phase (L, N, G), NOT Split Phase like USA standard (L1, L2+N, G). Wired control ONLY applies to pure sine wave inverter

Wired control (3m) or Wireless control (20m) NOT provide split phase configuration (L1, L2+N, G) This 12V DC to AC power inverter produces 2000 Watt continuous and 4000 Watt peak power, 110V/120V and 220V/230V/240V AC power for choice, ideal for car or home use to power devices or appliances.ДЎ-Phase (L, N, G) 110V/120V AC В±5% or 220V/230V/240V AC В±5%